Autotronics Laboratory

Sub Code: 12145

List of Experiments:
Part A

  1. Study of General Electrical System in an Automobile.
  2. Removing and REPLACING a BATTERY from a car.
  3. TESTING THE BATTERY: Hydrometer Test – Open Circuit Voltage and High Rate Discharge Testing.
  4. Study of the Battery Charger and Charging the Run Down Battery.
  5. Identification of Various components of Ignition system, Dismantling Assembly of a Distributor, Setting Contact Breaker Points and Servicing of Spark Plugs.
  6. Setting Ignition Timing with Timing Light and Start the engine.
  7. Dismantling and Overhauling of a Starter Motor.
  8. Dismantling and Overhauling of a Dynamo.
  9. Dismantling and Overhauling of an Alternator.
  10. Servicing of Regulator.
  11. Adjusting the Sealed Beam Head Lamp.
  12. Servicing and tune up of the Horn.
  13. Servicing a Wiper Motor.

    Part B
  14. Study of BASIC ELECTRONICS
    ( Semi Conductor Materials – N type and P type PN junction – forward and reverse bras, characteristics of PN diode – Half wave rectifier full wave rectifier bridge rectifier, zener and avalanche break – down, Characters of Zener diode – application of Zener diode ).
  15. Construction of a half wave rectifier without filter.
  16. Construction of a bridge wave rectifier without a filter.
  17. Measurement of voltage, current and resistance by using multimeter (both analog and digital) in all ranges.
  18. Verification of truth table for AND, OR, NOT, NOR, NAND, EX OR, and EX NOR gates.
  19. Study of PLC.
  20. Exercise on Various sensors used in automobiles.
  21. Direct Operation of a motor using latch Circuit using PLC.
  22. ON/Off Stroke Timer control of a motor using PLC.

From the Web

Suggestions: (1)
Loading...

See few results | more results

Search: [Press Enter]

Share |